-
-
Install the thrust needle bearing (A), the 3rd gear (B), the needle bearing (C), the thrust needle bearing (D), the 40 x 63 mm thrust washer (E), the 3rd/5th clutch (F), the 5th gear collar (G), and the transmission housing bearing (H) on the mainshaft (I). Do not install the O-rings during inspection.
-
Install the idler gear (J) on the mainshaft by a press, then install the conical spring washer (K) and the locknut (L).
-
Tighten the locknut to 29 N·m (3.0 kgf·m, 22 lbf·ft).
|
|