A/T Mainshaft Disassembly, Inspection, and Reassembly
-
Inspect the thrust needle bearing and the needle bearing for galling and rough movement.
-
Inspect the splines for excessive wear and damage.
-
Check the shaft bearing surface for scoring and excessive wear.
-
Before installing the O-rings, wrap the shaft splines with tape to prevent O-ring damage.
-
Lubricate all parts with ATF during assembly.
-
Install the conical spring washer, the 40 x 63 mm thrust washer in the direction shown.
-
Replace the locknut and the conical spring washer with new ones when assembling the transmission.
-
|
|
-
Inspect the thrust needle bearing and the needle bearing for galling and rough movement.
|
|
-
Inspect the splines for excessive wear and damage.
-
Check the shaft bearing surface for scoring and excessive wear.
-
Before installing the O-rings, wrap the shaft splines with tape to prevent O-ring damage.
-
Lubricate all parts with ATF during assembly.
-
Install the conical spring washer, the 40 x 63 mm thrust washer in the direction shown.
-
Replace the locknut and the conical spring washer with new ones when assembling the transmission.
-
|