-
Disconnect the connectors (A) from A/T clutch pressure control solenoid valve B and C.
-
Remove A/T clutch pressure control solenoid valve B and C.
-
Remove the ATF pipe (D), ATF joint pipes (E), O-rings (F), and gasket (G).
-
Clean the mounting surface and fluid passages of the transmission housing.
-
Install the new gasket with blue side down; white side up on the transmission housing.
-
Install the ATF pipe and ATF joint pipes, and install the new O-rings over the ATF joint pipes.
-
Install A/T clutch pressure control solenoid valve B and C.
-
Check the connectors for rust, dirt, or oil, clean or repair if necessary, then connect the connectors securely.
-
Install the breather hose clamp bracket, and install the breather hose on its clamp at the dot.
-
|
|