-
Disconnect A/T clutch pressure control solenoid valve connector (A).
-
Remove the mounting bolts and A/T clutch pressure control solenoid valve A (B).
-
Remove the ATF pipe (C), ATF joint pipes (D), O-rings (E), and gasket (F).
-
Clean the mounting surface and fluid passages of the transmission housing.
-
Install the new gasket with blue side down; white side up on the transmission housing.
-
Install the ATF pipe and ATF joint pipes, and install the new O-rings over the ATF joint pipes.
-
Install A/T clutch pressure control solenoid valve A.
-
Install the transmission hanger/air cleaner housing bracket, and secure the ATF cooler line/hose bracket and harness cover with the bolts.
-
Check the connector for rust, dirt, or oil, clean or repair if necessary, then connect the connector securely.
-
|
|