-
Connect a jumper wire from the negative battery terminal to A/T clutch pressure control solenoid valve A connector terminal No. 2, and connect another jumper wire from the positive battery terminal to the connector terminal No. 1. Make sure A/T clutch pressure control solenoid valve A moves.
-
Disconnect one of the jumper wires, and check valve movement at the fluid passage in the valve body mounting surface. If the valve binds or moves sluggishly, or if the solenoid valve does not operate, replace A/T clutch pressure control solenoid valve A.
-
Clean the mounting surfaces and fluid passages of the solenoid valve body and transmission housing.
-
Install the new gasket with blue side down; white side up on the transmission housing.
-
Install the ATF pipe and ATF joint pipes, and install the new O-rings over the ATF joint pipes.
-
Install A/T clutch pressure control solenoid valve A.
-
Install the transmission hanger/air cleaner housing bracket, and secure the ATF cooler line/hose bracket and harness cover with the bolts.
-
Check the connector for rust, dirt, or oil, clean or repair if necessary, then connect the connector securely.
-
|
|