-
Align the spring pin (A) on the selector control shaft (B) with the transmission housing groove (C) by turning the control shaft with the detent plate.
NOTE: Do not squeeze the end of the selector control shaft tips together when turning the control shaft.
-
Install the special tool over the mainshaft, then remove the transmission housing, dowel pins, and gasket.
NOTE: If the top arm of your housing puller is too short, replace it with housing puller arm, 205 mm 07SAC-P0Z0101.
-
Remove the countershaft reverse gear and needle bearing.
-
Remove the lock bolt securing the shift fork, then remove the shift fork with the reverse selector together.
|
|