Special Tools Required
Mainshaft holder set
07PAB-0010001
-
Remove the bolts securing the ATF inlet line (A) and ATF filter holder (B), line bolt and sealing washers, and remove the ATF inlet line, ATF hose, and ATF filter. Remove the ATF filter bracket (C).
-
Remove the ATF outlet line bolt, line mounting bolt, sealing washers, and ATF outlet line (D).
-
Remove the transmission hanger (E) and breather hose clamp bracket (F).
-
Remove the A/T clutch pressure control solenoid valve A (G), ATF joint pipes, O-rings, ATF pipe, and gasket.
-
Remove the A/T clutch pressure control solenoid valve B and C (H), O-rings, ATF pipe, ATF joint pipes, and gasket.
-
Remove the input shaft (mainshaft) speed sensor (I) and output shaft (countershaft) speed sensor (J).
-
Remove the transmission range switch cover (K).
-
Remove the transmission range switch harness clamps (L) from the clamp bracket (M), then remove the transmission range switch (N).
-
Remove the clamp bracket from the end cover (O).
-
Remove the connector bracket (P) from the transmission housing.
-
Remove the end cover, dowel pins, O-rings, and end cover gasket.
-
Remove the ATF lubrication pipe (Q) from the idler gear shaft.
|
|