-
Slide the ATF cooler hose (A) on the ATF filter (B) until the hose end contacts the filter housing, and secure the hose with the clip (C) at 6−8 mm (0.24−0.31 in.) (D) from the filter housing. Install the cooler hose on the other side of the ATF filter in the same manner.
-
Slide the ATF cooler hoses (E) over the ATF lines (F) until the hose ends contact the bulge (G), and secure the hoses with the clip (H) at 6−8 mm (0.24−0.31 in.) (I) from the hose end.
-
Slide the ATF cooler hose (J) over the ATF line (K) until the hose end contacts the line bracket (L), and secure the hose with the clip (M) at 6−8 mm (0.24−0.31 in.) (N) from the hose end.
-
Slide the ATF cooler hose (O) over the ATF cooler line (P) until the hose end contacts the bulge (Q), and secure the hose with the clip (R) at 2−4 mm (0.08−0.16 in.) (S) from the hose end.
|
|