The idle learn procedure must be done so the ECM/PCM can learn the engine idle characteristics.
Do the idle learn procedure whenever you do any of these actions:
NOTE: Clearing the DTCs with the HDS does not require you to do the idle learn procedure.
Procedure
-
Make sure all electrical items (A/C, audio, lights, etc.) are off.
-
Reset the ECM/PCM with the HDS.
-
Turn the ignition switch to ON (II), and wait 2 seconds.
-
Start the engine. Hold the engine speed at 3,000 rpm (min
−1
) without load (A/T in P or N, M/T in neutral) until the radiator fan comes on, or until the engine coolant temperature reaches 90 °C (194 °F).
-
Let the engine idle for about 5 minutes with the throttle fully closed.
NOTE: If the radiator fan comes on, do not include its running time in the 5 minutes.
-
Verify on the HDS data list that the idle learn procedure is complete.
|