DTC 12-Ax (‘‘x'' can be 0 thru 9 or A thru F):
Short to Power in the Driver's Airbag Second Inflator (RHD model)
Special Tools Required
SRS short canceller
070AZ-SAA0100
NOTE:
-
-
Turn the ignition switch to ON (II), then wait for 10 seconds.
-
-
Turn the ignition switch to LOCK (0).
-
Disconnect the negative cable from the battery, then wait at least 3 minutes.
-
-
-
Reconnect the negative cable to the battery.
-
Turn the ignition switch to ON (II), then wait for 10 seconds.
-
Measure the voltage between the No. 9 and the No. 10 terminals of SRS unit connector A (39P) and body ground. There should be less than 1.0 V.
Is the voltage as specified?
|
-
Turn the ignition switch to LOCK (0).
-
Disconnect the negative cable from the battery, then wait at least 3 minutes.
-
-
Reconnect the negative cable to the battery.
-
Turn the ignition switch to ON (II), then wait for 10 seconds.
|