( TF09E00K801000R6611FAAT00 )
VSA DTC Troubleshooting: 66-11, 66-14, 66-16, 66-17, 66-18, 66-19
DTC 66-11:
 Pressure Sensor (Inside of VSA Modulator-control Unit) Malfunction
DTC 66-14:
 Pressure Sensor (Inside of VSA Modulator-control Unit) Malfunction
DTC 66-16:
 Pressure Sensor (Inside of VSA Modulator-control Unit) Malfunction
DTC 66-17:
 Pressure Sensor (Inside of VSA Modulator-control Unit) Malfunction
DTC 66-18:
 Pressure Sensor (Inside of VSA Modulator-control Unit) Malfunction
DTC 66-19:
 Pressure Sensor (Inside of VSA Modulator-control Unit) Malfunction
  1. Turn the ignition switch to ON (II).
  1. Clear the DTC with the HDS.
  1. Turn the ignition switch to LOCK (0), then turn it to ON (II) again.
  1. Check for DTCs with the HDS.
Is DTC 66-11, 66-14, 66-16, 66-17, 66-18, or 66-19 indicated?
YES -
Go to Step 5 .
NO -
Intermittent failure, the system is OK at this time.■
  1. Turn the ignition switch to LOCK (0), then turn it to ON (II) again.
  1. Check for DTCs with the HDS.
Is DTC 66-11, 66-14, 66-16, 66-17, 66-18, or 66-19 indicated?
YES -
Check for loose terminals in the VSA modulator-control unit 36P connector. If the VSA modulator-control unit was updated, substitute a known-good VSA modulator-control unit, then retest. If the VSA modulator-control unit was substituted, go to Step 1 .
NO -
If the VSA modulator-control unit was updated, troubleshooting is complete. If the VSA modulator-control unit was substituted, replace the original VSA modulator-control unit. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.■