( TF09E00K722000R3301FAAT00 )
EPS DTC Troubleshooting: 33-01
DTC 33-01:
 Lower FET Stuck ON (Initial Diagnosis)
  1. Turn the ignition switch to ON (II).
  1. Clear the DTC with the HDS.
  1. Turn the ignition switch to LOCK (0).
  1. Start the engine.
  1. Turn the steering wheel from lock to lock several times, and hold the steering wheel for 10 seconds or more.
  1. Check for DTCs with the HDS.
Is DTC 33-01 indicated?
YES -
Go to Step 7 .
NO -
Intermittent failure, the system is OK at this time.■
  1. Turn the ignition switch to LOCK (0).
  1. Disconnect the EPS control unit connector B (2P).
  1. Check for continuity between body ground and EPS control unit connector B (2P) No. 1 terminal, and No. 2 terminal.
Is there continuity?
YES -
Go to Step 10 .
NO -
Check for loose terminal in the EPS control unit connectors, and repair if necessary. If no poor connections are found, replace the EPS control unit. ■
  1. Disconnect the EPS motor 2P connector.
  1. On the EPS motor side, check for continuity between body ground and EPS motor 2P connector No. 1 terminal, and No. 2 terminal.
Is there continuity?
YES -
NO -
Repair short to body ground in the wire between the EPS control unit and EPS motor.■