Driver's Window Resetting and Learning
Resetting and learning the driver's window is required when any of the following have occurred:
-
Power window regulator replacement or repair
-
Power window motor replacement or repair
-
Window run channel replacement or repair
-
Driver's door glass replacement or repair
-
Power is removed from the power window control unit while the power window key-off operation timer is ON.
-
Turn the ignition switch to LOCK (0).
-
Press and hold the driver's window DOWN switch.
-
Turn the ignition switch to ON (II).
-
Release the driver's window DOWN switch.
-
Repeat
Step 1
−4 three more times.
-
Check if the AUTO UP and AUTO DOWN functions still work.
-
If they still work, AUTO UP and AUTO DOWN functions have not been cleared; go back to
Step 1
.
-
If they do not, go to
Step 7
.
-
Turn the ignition switch to ON (II).
-
Move the driver's window all the way down by using the driver's window DOWN switch.
-
Pull up and hold the driver's window UP switch until the window reaches the fully closed position, then continue to hold the switch for 1 second.
-
Make sure that the power window control unit is reset and learned by using the driver's window AUTO UP and AUTO DOWN functions.
|