Pulser Test
-
Reconnect the 6P connector to the driver's power window motor.
-
Turn the ignition switch to ON (II).
-
Measure the voltage between the terminals.
-
There should be battery voltage between the No. 5 (+) and No. 2 (−) terminals.
-
Connect an analog voltmeter between the No. 6 (+) and No. 2 (−) terminals, and run the window motor down or up. The voltmeter needle should move back and forth alternately (a digital voltmeter reads about 2.5 V).
-
Connect an analog voltmeter between the No. 3 (+) and No. 2 (−) terminals, and run the window motor down or up. The voltmeter needle should move back and forth alternately (a digital voltmeter reads about 2.5 V).
-
-
If the switch is OK, replace the power window motor.
-
|
|