-
Apply multipurpose grease to all the sliding surfaces of the regulator (A) where shown.
-
Install the glass and regulator in the reverse order of removal, and note these items:
-
Raise and lower the glass to see if it moves freely without binding.
-
Make sure that there is no clearance between the glass and glass run channel when the glass is closed.
-
-
-
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
-
-
Test-drive and check for wind noise and rattles.
-
Make sure the power door locks, windows and power mirror operate properly.
|
|