Windshield
-
-
Disconnect the 5P connector (B) from the wiper motor (C).
-
Test the motor by connecting battery power to the No. 4 [No. 3] terminal and ground the No. 5 [No. 4] terminal of the wiper motor 5P connector. The motor should run at low speed. If the motor does not run, or fails to run smoothly, replace the motor.
-
Test the motor by connecting battery power to the No. 1 [No. 5] terminal and ground the No. 5 [No. 4] terminal of the wiper motor 5P connector. The motor should run at high speed. If the motor does not run, or fails to run smoothly, replace the motor.
-
Connect an analog ohmmeter to the No. 3 [No. 1] and No. 5 [No. 4] terminals, and run the motor at low or high speed. The needle of the ohmmeter should pulse. If it does not, replace the motor.
[ ]: LHD model
|
|