Make sure the ignition switch is in LOCK (0).

Disconnect the negative battery cable, then disconnect the positive cable, and wait at least 3 minutes.

RHD model: Remove the fuse lid panel, and remove the driver's dashboard lower cover. LHD model: Remove the fuse lid panel.

Disconnect the connectors from the front side of the under-dash fuse/relay box (A).

Remove the mounting bolts, and the terminal (B).

Release the lock (C) and pull the fuse/relay box away from the body.

Disconnect the connectors from the back side of the under-dash fuse/relay box, then remove the under-dash fuse/relay box.

Carefully remove the relays by prying under the base of the relay.

NOTE: Do not use pliers. Pliers will damage the relays, which could cause the engine to stall or not start.

Install the relays and connect the connectors to the under-dash fuse/relay box, then install the under-dash fuse/relay box in the reverse order of removal.

Install the removed parts in the reverse order of removal.

Connect the positive cable to the battery, then connect the negative cable to the battery.

Set the clock (if equipped).

Make sure that all systems work properly.