NOTE:
-
The HDS is required for registration of the immobilizer keys.
-
Check for aftermarket electrical equipment that can cause problems with transponder operation.
-
The immobilizer control unit-receiver can store up to six immobilizer Keys.
Replace any of the keys
NOTE: If any of the registered keys were lost, do the following procedure to delete the lost registered key.
-
Have at least one original key, all other keys to be registered and the immobilizer ECM/PCM code.
-
Connect the HDS to the data link connector.
-
Turn the ignition switch to ON (II).
-
Select ‘‘IMMOBILIZER'' from the ‘‘SYSTEM SELECTION MENU''.
-
Select ‘‘KEYS'' from the ‘‘IMMOBILIZER MENU'', then select ‘‘REWRITE KEYS''.
-
Select ‘‘REWRITE KEYS'' from the ‘‘KEYS''.
-
Do the registration according to the instruction of HDS screen.
-
Check if the engine can be started by all the registered keys.
All keys are lost
-
Prepare all new keys and have the immobilizer ECM/PCM code.
-
Connect the HDS to the data link connector.
-
Turn the ignition switch to ON (II).
-
Select ‘‘IMMOBILIZER'' from the ‘‘SYSTEM SELECTION MENU''.
-
Select ‘‘KEYS'' from the ‘‘IMMOBILIZER MENU'', then select ‘‘REWRITE KEYS''.
-
Select ‘‘ALL KEYS LOST'' from the ‘‘KEYS''.
-
Do the registration according to the instruction of HDS screen.
-
Check if the engine can be started by all the registered keys.
|