Immobilizer indicator blinks
NOTE: Before troubleshooting, check the items listed in ‘‘General Check before Troubleshooting''.
-
Turn the ignition switch to LOCK (0).
-
Connect the HDS, then turn the ignition switch to ON (II).
-
Enter the IMMOBILIZER, then select the IMMOBILIZER SETUP.
-
Select the SYSTEM CHECK.
Is the SYSTEM CHECK indicated?
|
YES
|
-
|
Troubleshoot the immobilizer system according to the result of the SYSTEM CHECK.■
|
NO
|
-
|
|
-
Turn the ignition switch to LOCK (0).
-
Enter the vehicle, and remove the ignition key from the ignition switch, then close all the doors.
-
Operate the keyless transmitter LOCK and UNLOCK several times in the vehicle.
Do the door lock actuators work normally?
|
YES
|
-
|
|
NO
|
-
|
Check for a poor ground (G101) and/or an open in the wire between the immobilizer-keyless control unit 7P connector No. 7 terminal and body ground (G101).■
|
-
Turn the ignition switch to ON (II).
-
Measure the voltage between the immobilizer-keyless control unit 7P connector No. 2 terminal and body ground.
Is there battery voltage?
|
YES
|
-
|
|
NO
|
-
|
Repair an open in the RED wire between the under-dash fuse/relay box and the immobilizer-keyless control unit.■
|
|