NOTE:
-
Take care not to tear the seams or damage the seat covers.
-
Put on gloves to protect your hands.
-
Take care not to kink the cable.
-
The left rear seat cushion is shown, the right rear seat cushion is similar.
-
-
-
-
Fold the leg, and remove the wire tie (A).
-
Disconnect the control cable (B) from the leg end (C) and cable bracket (D) of the seat cushion frame.
-
Install the cable in the reverse order of removal, and note these items:
-
Replace the wire tie you removed with new ones.
-
Make sure the control cable is routed properly and connected securely.
-
Fix at the original position in the end of the cable on the cable bracket securely. And check the rear seat tip-up operation:
Make sure the rear seat cushion unlocks by lifting the leg. If necessary, adjust the position of the cable end.
|
|