Front Seat Recline Cover Removal/Installation
SRS components are located in this area.
Review the SRS component locations
and
the precautions and procedures
before doing repairs or service.
NOTE:
Put on gloves to protect your hands.
Take care not to tear the seams or damage the seat covers.
When removing components, use the trim tools or equivalent.
RHD model is shown; LHD model is similar.
Outer recline cover
Remove the front seat.
Manual height adjustable seat: Pull back the cap (A) to release the hooks (B), and remove the screws, then remove the height handle (C).
Remove the recline outer cover (A).
-1.
Fold back the seat to fully.
-2.
Remove the recline knob (B), and remove the screw.
-3.
Using a trim tool, and release the hooks (C) of the outer cover from the recline inner cover (D).
-4.
Detach the clip by pulling the outer cover back by hand.
-5.
Gently pull out the outer cover and remove it.
Inner recline cover
Remove the front seat cushion cover/pad.
Remove the recline inner cover (A).
-1.
Release the hooks (B) of the recline inner cover from the seat cushion frame.
-2.
Pull out the cover by removing the holder of the cover from the seat cushion frame pipe (C).
When installing the inner cover; securely fit the hooks on the seat cushion frame first, next fit the holder of the cover on the cushion pipe.
Driver's seat
Passenger's seat