-
Turn the individual map light switch OFF.
-
Carefully pry the lens (A) off with a small screwdriver.
Individual Map Light:
|
8 W x 2
|
-
Remove the screws, then remove the individual map light (B).
-
Disconnect the connector (C) from the individual map light.
-
Check for continuity between the terminals.
-
There should be continuity between the No. 1 terminal and ground terminal with the switch in the ON position.
-
There should be no continuity between the No. 1 terminal and ground terminal with the switch in the OFF position.
-
If the continuity is not as specified, check the bulb. If the bulb is OK, replace the individual map light.
-
Install the light in the reverse order of removal.
|
|