-
Turn the ceiling light switch OFF.
-
Carefully pry the lens (A) off with a small screwdriver.
-
Remove the screws, then remove the ceiling light (B).
-
Disconnect the 3P connector (C) from the ceiling light.
-
Check for continuity between the terminals.
-
There should be continuity between the No. 1 and No. 2 terminals with the switch in the MIDDLE position.
-
There should be continuity between the No. 2 and No. 3 (Body ground) terminals with the switch in the ON position.
-
There should be no continuity between the No. 1 and No. 2 terminals, and between the No. 2 and No. 3 (Body ground) terminals with the switch in the OFF position.
-
If the continuity is not as specified, check the bulb. If the bulb is OK, replace the ceiling light.
-
Install the light in the reverse order of removal.
|
|