NOTE:
-
Take care not to scratch the dashboard and its related parts.
-
When removing components, use the trim tools or equivalent.
-
RHD model is shown; LHD model is symmetrical.
-
Tilt the steering column down.
-
Remove the instrument panel (A).
-1.
|
Pull out the select/reset knob (B).
|
-2.
|
While carefully lifting the panel with the appropriate trim tool, insert the trim tool into the gap (C) between the dashboard and the panel.
|
-3.
|
Use the trim tool to gently pry the panel up partially to release the clips (D, E) and the hooks (F), then pull the panel up to release the panel.
|
-4.
|
Disconnect the power mirror switch connector (G).
|
-
Install the panel in the reverse order of removal, and note these items:
-
Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
-
Push the clips and the hooks into place securely.
-
Make sure each connector is plugged in properly.
-
Make sure the select/reset knob operate properly.
|
|