( TF09E00J26216516401KDAT02 )
Center Console Removal/Installation - With Seat Heater
With Seat Heater
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE:
  • Take care not to scratch the front seat, dashboard, and related parts.
  • When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
  • LHD model is shown; RHD model is symmetrical.
  1. M/T model: Remove the shift knob (A).
  1. Remove the center console (A).
    -1.
    Remove the parking brake cover lid (B).
    -2.
    Remove the switch panel (C), then disconnect the seat heater connector (D).
    -3.
    Detach the harness clip (E), then remove the switch panel base (F).
    -4.
    Remove the console box mat (G), then remove the bolt (H) and the clips (I).
    -5.
    Lift the rear of the console up to detach the clip (J).
  1. Install the trim in the reverse order of removal, and note these items:
    • If the clips are damaged or stress-whitened, replace them with new ones.
    • Push the clips into place securely.
    • Make sure the wire harness is not pinched.