Center Console Removal/Installation - Without Seat Heater
SRS components are located in this area.
Review the SRS component locations
and
the precautions and procedures
before doing repairs or service.
NOTE:
Take care not to scratch the front seat, dashboard, and related parts.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
RHD model is shown; LHD model is symmetrical.
M/T model: Remove the shift knob (A).
Remove the center console (A).
-1.
Remove the parking brake cover lid (B), separation box (C), and center console lid (D).
-2.
Remove the console box mat (E), then remove the bolt (F) and the clips (G).
-3.
Lift the rear of the console up to detach the clip (H).
Install the trim in the reverse order of removal, and note these items:
Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
Push the clips into place securely.
Make sure the wire harness is not pinched.