For Some Models
-
Remove the side sill panel (A).
-1.
|
On the back of the front wheel arch, remove the clips (B).
|
-2.
|
Remove the expansion clips (C).
|
-3.
|
Slide the side sill panel forward, and remove it. The side clips (D, E, F) will stay in the body.
|
-4.
|
Remove the side clips (D, E) from the body by turning them 45 °.
|
-5.
|
If necessary, use a utility knife to cut the double-sided adhesive tape (G) that holds the side clips (F) to the body. Take care not to scratch the body.
|
-
Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
-
If the side clips (F) will be reinstalled, remove any remaining double-sided adhesive tape from the side clips, then clean the side clip surfaces with a sponge dampened in isopropyl alcohol where new double-sided will be attached. Apply primer to the side clips, then attach new double-sided adhesive tape.
-
Clean the body surface with a sponge dampened in isopropyl alcohol where adhesive tape will be attached.
|
|