-
Pull out the rear license trim (A) to detach the pins (B) of the clips from the grommets (C), then remove the trim from the tailgate.
-
Using snap ring pliers, remove the grommets from the tailgate.
-
Check if the grommets and pins are damaged or stress-whitened, and if necessary, replace grommets and pins as an assembly with new ones.
-
Install the grommets on the pins by pushing them into place.
-
Install the trim in the reverse order of removal, and note these items:
-
Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
-
Do not roll up the lip (D) of the rear window rubber dam. If necessary for proper attachment, set a plastic plate between the lip and the trim. Install the top edge of the trim while sliding a plastic plate sideward. Be careful not to cut the lip.
-
Push the clips into place securely.
|
|