Rear Door Outer Handle Replacement
NOTE:
Put on gloves to protect your hands.
Take care not to scratch the door and related parts.
When removing components, use the trim tools or equivalent.
RHD model is shown; LHD model is symmetrical.
Remove the door panel.
Raise the glass fully.
Remove the plastic cover, as needed.
Remove the maintenance caps (A).
Detach the rod fastener (A), then disconnect the outer handle rod (B) with a clip remover.
Remove the outer handle (A).
-1.
Remove the bolts.
-2.
Apply protective tape (B) to the door panel (C) as shown.
-3.
Pry out the outer handle with the appropriate trim tool (D) to release the hook (E), then remove it.
NOTE: Take care not to scratch the door.
Remove the rod fastener (A) from the outer handle base (B), then replace it with a new one.
Install the handle (A) in the following order.
-1.
Set the upper portion (B) of the handle to the edge (C) of the door panel.
-2.
While pulling up the handle, push the lower hook (D) into place.
NOTE: Push the hook into place securely.
Install the removed parts in the reverse order of removal, and note these items:
Make sure that the outer handle rod are connected securely.
Make sure the door handle works properly.
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
Check for water leaks.