( TF09E00J16166220801KBAT00 )
Rear Door Latch Replacement
NOTE:
  • Put on gloves to protect your hands.
  • Take care not to scratch the door and related parts.
  • RHD model is shown; LHD model is symmetrical.
Latch Replacement
  1. Raise the glass fully.
  1. Detach the harness clip (A), then disconnect the power door lock actuator connector (B).
  1. Remove the plug caps (C), then remove the plastic cover (D), as needed.
  1. Detach the latch cable fastener (A) from the latch cable (B).
  1. Disconnect the latch cable (A) from the lock knob (B).
  1. Detach the inner handle cable fastener (A) from the inner handle cable (B).
  1. Disconnect the inner handle cable (A) from the lock knob (B).
  1. Remove the bolt, and loosen the nut, then pull the rear lower channel (A) forward.
  1. Remove the screws (A, B), then remove the latch (C) through the gap between the rear lower channel and door.
    NOTE: Take care not to bend the latch cable, the inner handle cable.
  1. Install the latch in the reverse order of removal, and note these items:
    • Make sure the actuator connector is plugged in properly.
    • Make sure the door locks and opens properly.
    • When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
    • Check for water leaks.
Cable Replacement
  1. Remove the door latch.
  1. Remove the screws, then remove the latch protector (A).
Indonesia-produced models
Thailand-produced models
  1. Disconnect the latch cable (A) and the inner handle cable (B).
  1. Install the cable in the reverse order of removal, and note these items:
    • Make sure the latch cable and inner handle cable are connected securely.
    • Make sure the door locks and opens properly.
    • When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
    • Check for water leaks.
Indonesia-produced models
Thailand-produced models