|
NOTE:
-
Take care not to scratch the door and related parts.
-
Use a clip remover to remove the clips.
-
RHD model is shown; LHD model is symmetrical.
-
At the front pillar, remove the door checker mounting bolt (A).
-
Detach the clips (B, C, D, E), then remove the door weatherstrip (F).
-
Install the weatherstrip in the reverse order of removal and note these items:
-
Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
-
Make sure the weatherstrip is installed in the holder (G) securely.
-
Apply medium strength type liquid thread lock to door stop mounting bolt before installation.
-
|
|
