-
-
Remove the bolt (B) and the screws (C) securing the latch (D), then remove the latch through the hole in the door.
NOTE: Take care not to bend the outer handle rod, the latch cable (E), and the inner handle cable (F).
-
Install the latch in the reverse order of removal, and note these items:
-
Make sure the actuator connector is plugged in properly, and each rod is connected securely.
-
Make sure the door locks and opens properly.
-
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
-
Check for water leaks.
|
|