Installation
NOTE:
-
If the side airbag lid is secured with tape, remove the tape.
-
Do not open the lid on the side airbag cover.
-
Use new mounting nut tightened to the specified torque.
-
Make sure that the seat-back cover/pad is installed properly. Improper installation may prevent proper deployment.
-
Be sure to install the harness so that they are not pinched or interfering with other parts.
-
Place the side airbag (A) on the seat-back frame. Torque the new side airbag mounting nut (B).
-
Install the rear hooks (C) in the seat-back frame (D).
-
-
-
Move the front seat and the seat-back through their full ranges of movement, making sure the harness are not pinched or interfering with other parts.
-
-
-
After installing the side airbag, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.
|
|