When a seat-back cover/pad and/or OPDS unit is replaced, initialize the OPDS by doing this procedure.
NOTE: A new (uninitialized) OPDS unit installed with a faulty OPDS sensor can cause DTC 85-71 or 85-78.
-
-
Make sure the front passenger's seat is dry. Set the seat-back in a normal position, and make sure there is nothing on the seat.
-
Make sure the ignition switch is in LOCK (0).
-
Connect the HDS to the data link connector (DLC) (A).
-
Turn the ignition switch to ON (II).
-
-
From the HDS Main Menu, select SRS, then SRS, then Calibration. In the Calibration Menu, select OPDS UNIT INITIALIZATION. Follow the screen prompts to initialize the OPDS unit.
-
Turn the ignition switch to LOCK (0).
-
Disconnect the HDS from the DLC.
NOTE: If the OPDS unit fails to initialize after several attempts, replace the OPDS sensor/seat-back and retry. If the OPDS unit continues to fail to initialize,
replace the OPDS unit.
|