( TF09E00H46400012802KBAT00 )
Driver's Airbag Replacement
Removal
  1. Do the battery terminal disconnection procedure, then wait for 3 minutes before starting work.
  1. Remove the access panel (A) from the steering wheel, then disconnect the driver's airbag 4P connector (B) and horn switch 1P connector (C) from the cable reel.
  1. Using a TORX T30 bit, remove the two TORX bolts (A).
  1. Remove the driver's airbag (B).
Installation
  1. Place the driver's airbag (A) in the steering wheel, and secure it with new TORX bolts (B).
    NOTE: Make sure the clearance (C) between the steering wheel and horn pad is the specified value.
  1. Connect the driver's airbag 4P connector (A) and horn switch 1P connector (B) of the cable reel, then install the access panel (C) on the steering wheel.
  1. Connect the HDS, and clear the DTCs.
  1. After installing the airbag, confirm proper system operation:
    • Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.
    • Make sure the horn and turn signal switches work properly.
    • Make sure the steering wheel switches work properly.