( TF09E00G10110200000KBAT00 )
A/C Condenser Replacement
  1. Remove the nut, then disconnect the discharge hose (A) from the A/C condenser. From the discharge hose, remove the O-ring (B).
  1. Remove the bolt, then disconnect the receiver line (A) from the A/C condenser. From the receiver line, remove the O-ring (B).
  1. Remove the bolts (A), disconnect the connector (B), and remove the horn (C). If equipped with the high horn (D), remove it.
  1. Remove the bolts (E) and the brackets (F).
  1. Remove the A/C condenser (A) by lifting it up.
    • Do not grab the upper seal (B).
    • Be careful not to damage the radiator and A/C condenser fins when removing the A/C condenser.
  1. Install the A/C condenser in the reverse order of removal, and note these items:
    • Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the correct O-rings for HFC-134a (R-134a) to avoid leakage.
    • Immediately after using the oil, reinstall the cap on the container, and seal it to avoid moisture absorption.
    • Do not spill the refrigerant oil on the vehicle; it may damage the paint; if the refrigerant oil contacts the paint, wash it off immediately.