Special Tools Required
Driver, 32.5 mm
070AD-SAA0100
-
-
Remove the tie-rod end from the rack end.
-
Remove the tie-rod ball joint boot from the tie-rod end, and wipe the old grease off the ball pin.
-
Pack the lower area of the ball pin (A) with fresh multipurpose grease.
-
Pack the interior of the new tie-rod ball joint boot (B) and lip (C) with fresh multipurpose grease.
Note these items when installing new grease:
-
Keep grease off the boot mounting area (D) and the tapered section (E) of the ball pin.
-
Do not allow dust, dirt, or other foreign materials to enter the boot.
|
|