Clean the areas where the intermediate shaft contacts the differential thoroughly with solvent or brake cleaner, and dry with compressed air.

NOTE: Do not wash the rubber parts with solvent.

Install a new set ring (A) onto the set ring groove (B) of the intermediate shaft (C).

Insert the intermediate shaft (A) into the differential correctly.

NOTE: Insert the intermediate shaft carefully to prevent damaging the oil seal.

Install the flange bolt (B) and the two dowel bolts (C).

Install the heat cover (D).

Install the control cable cover (A).

Install the right driveshaft.

Refill the transmission with the recommended transmission fluid.

Check the wheel alignment, and adjust it if necessary.

Test-drive the vehicle.