Raise the rear of the vehicle, and support it with safety stands in the proper locations.

Remove the rear wheel.

Release the parking brake lever fully.

Remove the caliper body and the brake pads from the caliper bracket.

Remove the caliper bracket (A) from the knuckle.

Remove the brake disc flat screws (A).

Remove the brake disc (B) from the hub bearing unit.

NOTE: If the brake disc is stuck to the hub bearing unit, thread two 8 x 1.25 mm bolts (C) into the brake disc to push it away from the hub bearing unit. Turn each bolt 90 degrees at a time to prevent the brake disc from binding.

Install the brake disc in the reverse order of removal, and note these items:

Clean the mating surfaces of the brake disc and the inside of the wheel, then install the rear wheel.