-
Remove the front hub or the rear hub bearing unit:
front
,
rear.
-
Separate the wheel bolt (A) from the hub (B) using a hydraulic press. Support the hub with hydraulic press attachments (C) or equivalent tools.
NOTE:
-
Before installing the new wheel bolt, clean the mating surfaces on the bolt and the hub.
-
The illustration shows a front hub.
-
Insert the new wheel bolt into the hub while aligning the splined surfaces on the hub hole with the wheel bolt.
NOTE:
-
Install the wheel bolt using a hydraulic press until the wheel bolt shoulder is fully seated.
-
Install the front hub or the rear hub bearing unit:
front
,
rear.
NOTE: If you cannot tighten the wheel nut to the specified torque value when installing the wheel, replace the front hub or the rear hub bearing unit as an assembly.
|
|