Raise the vehicle, and support it with safety stands in the proper locations.

Remove the dynamic damper from the axle beam.

Remove the stabilizer rubber (A) from the axle beam.

Apply osmosis preservation lubricant to the new stabilizer rubber. This will ease installation of the rubber into the stabilizer and the axle beam.

Make a mark (A) near the hole (B) of the axle beam as shown. Install the stabilizer rubber (C) into the axle beam by aligning the end face of the stabilizer rubber to the plant mark.

NOTE: Make sure the stabilizer rubber is installed into the stabilizer (D).

Install the dynamic damper to the axle beam.