Wheel Bearing End Play Inspection
-
-
Remove the wheels.
-
Install suitable flat washers (A) and the wheel nuts. Tighten the nuts to the specified torque to hold the brake disc securely against the hub.
-
Attach the dial gauge. Place the dial gauge against the hub flange.
-
Measure the bearing end play while moving the brake disc inward and outward.
Wheel bearing end play:
|
|
Front/Rear:
|
0−0.05 mm (0−0.002 in.)
|
-
If the bearing end play measurement is more than the standard, replace the wheel bearing or the hub bearing unit.
|
Front
Rear
|