-
-
Remove the front wheel.
-
Remove the self-locking nut (A) and the flange nut (B) while holding the respective joint pin (C) with a hex wrench (D), then remove the stabilizer link (E).
-
Install the stabilizer link on the stabilizer bar (F) and the damper (G) with the joint pins set at the center of their range of movement.
-
Install the new self-locking nut and the new flange nut, and tighten them to the specified torque values while holding the respective joint pin with a hex wrench.
-
Clean the mating surfaces of the brake disc and the inside of the wheel, then install the front wheel.
-
Test-drive the vehicle.
-
After 5 minutes of driving, tighten the self-locking nut again to the specified torque value.
|
|