( TF09E00A46500056941FEAT00 )
Starter Solenoid Test
  1. Remove the starter cable (A) and motor cable (B), then disconnect the connector (C).
  1. Check the hold-in coil for continuity between the S terminal and the armature housing (ground). There should be continuity.
    • If there is continuity, go to Step 4 .
    • If there is no continuity, replace the solenoid.
  1. Check the pull-in coil for continuity between the S terminal and M terminal. There should be continuity.
    • If there is continuity, the solenoid is OK.
    • If there is no continuity, replace the solenoid.
  1. Install in the reverse order of removal.