-
Remove the all of the old liquid gasket from the oil/air separator mating surfaces, the bolts, and the bolt holes.
-
Clean and dry the oil/air separator mating surfaces.
-
Apply liquid gasket (P/N 08C70-K0234M, 08C70-K0334M, or 08C70-X0331S) to the engine block mating surface of the oil/air separator and to the inner threads of the bolt holes.
NOTE:
-
Apply liquid gasket about 1.5 mm (0.06 in.) diameter bead along the broken line (A).
-
Do not install components if 5 minutes or more have passed after applying the liquid gasket. Instead, remove the old residue and reapply the liquid gasket.
|
|