Before disconnecting fuel lines or hoses, relieve pressure from the system by disabling the fuel pump and then disconnecting the fuel tube/quick connect fitting in the engine compartment.
With the HDS
-
Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
-
Turn the ignition switch to ON (II).
-
-
Turn the ignition switch to LOCK (0).
-
Remove the fuel fill cap to relieve the pressure in the fuel tank.
-
Turn the ignition switch to ON (II).
-
From the INSPECTION MENU of the HDS, select Fuel Pump OFF, then start the engine, and let it idle until it stalls.
NOTE:
-
Turn the ignition switch to LOCK (0).
-
|