-
After resurfacing the seat, inspect for even valve seating: Apply Prussian Blue compound (A) to the valve face. Insert the valve in its original location in the head, then lift it and snap it closed against the seat several times.
-
The actual valve seating surface (B), as shown by the blue compound, should be centered on the seat.
-
If it is too high (closer to the valve stem), you must make a second cut with the 67.5 ° cutter (intake) or 60 ° cutter (exhaust) to move it down, then one more cut with the 45 ° cutter to restore seat width.
-
If it is too low (close to the valve edge), you must make a second cut with the 30 ° cutter to move it up, then make one more cut with the 45 ° cutter to restore seat width.
NOTE: The final cut should always be made with the 45 ° cutter.
|
|