Remove the air cleaner housing assembly.

Remove the intake manifold chamber.

Remove the following engine wire harness connectors and wire harness clamps from the cylinder head:

Remove the harness holder mounting bolt and the ground cable, then remove the harness holder from the bracket.

Remove the cylinder head cover.

Remove the camshaft thrust cover.

Hold the camshaft with an open-end wrench, then loosen the bolt.

Remove the camshaft position (CMP) pulse plate.

Install the CMP pulse plate.

Hold the camshaft with an open-end wrench, then tighten the bolt.

Specified Torque

14 x 1.5 mm 34 N·m (3.5 kgf·m, 25 lbf·ft)

Install the camshaft thrust cover (A) with new O-ring (B).

Install the cylinder head cover.

Install the harness holder, then install the ground cable.

Install the following engine wire harness connectors and wire harness clamps from the cylinder head:

Install the intake manifold chamber.

Install the air cleaner housing assembly.