Cylinder Head Inspection for Warpage
-
-
-
Check the cylinder head for warpage. Measure along the edges, and three ways across the center.
Warpage
|
Standard (New):
|
0.07 mm (0.0028 in.)
|
Service Limit:
|
0.08 mm (0.0031 in.)
|
-
If warpage is less than 0.08 mm (0.003 in.) cylinder head resurfacing is not required.
-
If warpage is between 0.08 mm (0.003 in.) and 0.2 mm (0.008 in.), resurface the cylinder head.
-
Maximum resurface limit is 0.2 mm (0.008 in.) based on a height of 120 mm (4.72 in.).
Cylinder Head Height
|
Standard (New):
|
119.9−120.1 mm (4.720−4.728 in.)
|
|
|