Radiator and A/C Condenser Fan, Motor, and Shroud Removal and Installation
Removal
-
Remove the right side splash shield.
-
-
Raise the vehicle on the lift to full height.
|
|
-
Remove the A/C compressor clutch connector (A) from the clamp, then remove the harness clamps (B).
-
Lower the vehicle on the lift.
|
|
-
Disconnect the fan motor connectors (A), the hood latch switch connector (B), and the horn connector (C), then remove the ground cable (D) and the harness clamps (E).
|
RHD model
LHD model
|
-
Remove the bulkhead mounting bolts, and remove the hood opener cable clamp (A), then remove the bulkhead (B).
|
|
-
Remove the coolant reservoir (A).
-
Remove the condenser fan shroud assembly (B), then remove the radiator fan shroud assembly (C) from condenser fan shroud side.
|
|
-
Disassemble the fan shrouds.
|
|
Installation
-
Assemble the fan shrouds.
|
|
-
Install the radiator fan shroud assembly (A), then install the condenser fan shroud assembly (B).
-
Install the coolant reservoir (C).
|
|
-
Install the hood opener cable clamp (A), then install the bulkhead (B).
-
Apply body paint to the bulkhead mounting bolts.
|
|
-
Connect the fan motor connectors (A), the hood latch switch connector (B), and the horn connector (C), then install the ground cable (D) and the harness clamps (E).
-
Raise the vehicle on the lift to full height.
|
RHD model
LHD model
|
-
Install the A/C compressor clutch connector (A) to the clamp, then install the harness clamps (B).
-
Lower the vehicle on the lift.
-
|
|
-
Install the right side splash shield.
|
|